Dual H Bridge DC Stepper Motor Drive Controller Board Module L298N for Arduino

Description

1. L298N as main chip ST corporation production.
   
2. Low heatoutstanding anti-interference performance.
   
3. High working power to 46vlarge current can reach 3A MAX and continue current is 2A power 25w.
   
4. Can drive one 2-phase stepper motor one 4-phase stepper motor or two DC motors.
   
5. Built-in 78M05get power from drive powerhowever when drive power over12V please use the external 5v power as power supply.
6. Large capacity filter capacitanceafterflow protection diode more stable and reliable.
   
   
   • Specifications:
     
   1. Double H bridge drive
   2. Chip: L298N (ST NEW)
      
   3. Logical voltage: 5V
      
   4.  Drive voltage: 5V-35V
      
   5. Logical current: 0mA-36mA
      
   6.  Drive current: 2A(MAX single bridge)
      
   7.  Size:43 x 43 x 26mm
      
   8. Max power: 25W
      
   9.  Net weight: 25g
      Uses: 
   1. Driving stepper motor: The connection of driving a common 4 line 2 phase electric motor is shown in figure after enable ENA ENB Input the following driving timing from IN1-IN4-then the speed and direction of the stepper motor can be controlled.
      
   2. Driving DC motor: Because this module is driven by double H bridgeit can drive two motors simultaneously. after enable ENA ENB You can input the speed and direction of PWM signal drive motor 1 from IN1 IN2 You can input the speed and direction of PWM signal drive motor 2 from IN1 IN2

"""