Hp G31 Mothebroard Kit.
Kit Include : Hp Orig G31 + Intel C2D 2.4Ghz + Orig Fan + 1GB DDR-2 667 (2 Nos)
Warranty : 365 Days
Hp Original Motherboard G31 Without IDE Connector Only 4 SATA Port
Intel Original Tray Pack Core2Duo 2.9 Ghz Proccessor With Intel Original FAN
Processor Detail Core2Duo 2.93Ghz/3MB Cache/1066 FSB
Motherboard Panel, 2 SATA Cable, Driver CD
1Gb DDR2 667 Mhz RAM (2 nos) Total 2Gb
Detail of Board Below
Figure 1: The MS-7525 (Boston) motherboard
-
Manufacturer's motherboard name: MSI MS-7525
-
HP/Compaq name: Boston-GL6
-
Micro-ATX: 24.4 cm (9.6 inches) x 21.9 cm (8.6 inches)
-
800/1066/1333 MHz (processor dependent)
Socket type: 775
Motherboard supports the following processor upgrades:
-
Core 2 Duo E7xxx (Wolfdale-M)
-
Core 2 Duo E4x00 (Conroe)
-
Pentium E2xxx series (Conroe)
-
Celeron Dual Core E1xx0 series (Conroe)
-
Celeron 4xx series (Conroe)
-
Dual channel memory architecture
-
Two 240-pin DDR2 DIMM sockets
-
Non-ECC memory only, unbuffered
-
Supports up to 4 GB* on 32 bit PCs
-
32 bit PCs cannot address a full 4.0 GB of memory.
*Integrated video is not available if a graphics card is installed.
-
Integrated graphics using Intel GMA 3100
-
Also supports PCI Express x16 graphics cards
Audio
*Integrated video is not available if a graphics card is installed.
-
Audio CODEC: Realtek ALC662
-
5.1 channel high-definition audio
-
Interface: Integrated into motherboard
-
Technology: Realtek 8101E
-
Data transfer speeds: up to 10/100Mb/s
-
Transmission standards:10-Base-T Ethernet
Figure 2: Back I/O panel
1 - PS/2 mouse (green)
2 - Video Graphics Adapter
3 - RJ-45 Network (LAN)
4 - Audio: Line In (light blue)
5 - Audio: Line Out (lime)
6 - Audio: Microphone (pink)
7 - USB 2.0: 4
8 - PS/2 keyboard (purple)
-
One 24-pin ATX power connector
-
One 4-pin ATX power connector
-
One floppy drive connector
-
Two 12v fan connectors for CPU fan and PC fan
-
One 9-pin header for power button, reset button, power LED, and HDD LED
-
Two USB 2.0 headers supporting 4 USB ports or devices
-
One SPDIF audio output connector
-
One 9-pin audio header for headphone-out and microphone-in (yellow, Vista capable, requires matching front audio jack module)
-
One jumper for resetting BIOS settings
-
One jumper to disable BIOS password checking
Figure 3: layout
CAUTION: Do not change any jumper setting while the computer is on. Damage to the motherboard can result.
This motherboard has jumpers to clear the Real Time Clock (RTC) RAM in CMOS. In the default (normal) position the jumper is on pins 1-2.
To clear CMOS, follow these steps:
-
Temporarily set jumper JBAT1 to pins 2-3.
-
Wait 5-10 seconds and then return the jumper to pins 1-2.
-
On the next startup, enter BIOS setup to reset any custom BIOS settings.
The BIOS password is used to protect BIOS settings from unwanted changes.
To erase the BIOS password follow these steps:
-
Turn OFF the computer and unplug the power cord.
-
Remove the JPWD1 jumper.
-
Connect the power cord and turn on the PC.
-
Enter BIOS Setup Menu, you will find the previous password is cleared.
-
Turn off the PC and unplug the power cord.
-
Replace the JPWD1 jumper.
-
Turn on the PC and set a new password if necessary.