Microwave Radar Motion Sensor Switch Automatic Power On Fan Light 220V 5.8 Ghz

Microwave sensor detector, easy install microwave sensor switch,Free shipping 220V~240V AC,detection Range 360 degree, Day and Night function(adjustable)

Description

The product is a new saving-energy switch; it adopts microwave sensor mould with high-frequency electro-magnetic wave (5.8GHz), integrated circuit. It gathers automatism, convenience, safety, saving-energy and practicality functions. The wide detection field is consisting of detectors. It works by receiving human motion. When one enters the detection field, it can start the load at once and identify automatically day and night. Its installation is very convenient and its using is very wide. Detection is possible through doors, panes of glass or thin walls.

TECHNICAL SPECIFICATIONS

Power supply: 220-240VAC                     

Installation sit: indoors, ceiling mounting 

Power frequency: 50/60Hz                      

Reach:1-10m (radii.)adjustable

HF system: 5.8GHz CW radar, ISM band         

Time setting: 10sec to 30min

Max load: 1200W                              

Detection angle: 360degree

Transmission power: <0.2mW                  

Light control: 2-2000LUX

Power consumption: approx.0.5W

FUNCTION:

1.Can identify day and night: It can work in the daytime and at night when it is adjusted on the “sun” position (max). It can work in the ambient light less than 3LUX when it is adjusted on the “moon” position (min). As for the adjustment pattern, please refer to the testing pattern.

2.SENS adjustable: It can be adjusted according to using location; low sensitivity with only 1m (radius) for detection distance; High sensitivity could up to 8m (radius), it fits for large room.

3.Time-Delay is added continually: When it receives the second induction signals after the first induction, it will compute time once more on the basic of the first time-delay rest.

4.Time-Delay is adjustable. It can be set according to the consumer's desire. The minimum time is 10sec±3sec. The maximum is 12min±1min.

INSTALLATION:

1.Switch off the power.

2.Fix the bottom on the selected position with the inflated screw through the screw holes in the side of the sensor.

3.Connecting the power and the load to sensor as per the connection-wire sketch diagram.

4.Switch on the power and test it.

NOTE: The high-frequency output of this Sensor is <0.2Mw-that is just one 5000th of the transmission power of a mobile phone or the output of a microwave oven